|
|
Using the Parameter Setup Card: Mag Stripe Card ReaderNOTE: The parameters are preset at the factory. You will not need to set the parameters to begin using the encoder. To program numerical values, press and release the "Card Return Button". Each press will increase the value one digit at a time. Holding the button in will cause the value to increase rapidly. When the value nears the desired value, release the button and step it slowly to the exact value desired. If the desired value is overshot, you must hold the button in (value will increase); partially insert the card; release the button and retrieve the card. The value will now be reset to zero.
After the Parameter Setup Card cycles through and the ID is set, each time the card is partially inserted and removed, the display will change as follows:
|